Product Recognition
Certification Number	ZC10-14100004
Name	Smoke Detector
Short Description	The ZS6101US-5 is a Z-WAVE enabled smoke detector.
Long Description	The ZS6101US-5 is a Z-WAVE enabled smoke detector which is designed to sense smoke that comes into the detector's chamber and send Z-WAVE signal and warning sound (with audibility as 85dB at 3m) if it detects a certain density of smoke. The detector is battery operated and includes the ability to detects the battery level and will report an alert signal if the battery is under certain low level. The sensitivity of its sensor is meet both UL217 and EN14604 standard. The ZS6101US-5 also supports its firmware could updated over Z-WAVE network.
Brand	Vision
Product Identifier	ZS6101US-5
OEM Version	01
Hardware Platform	ZM5202
Z-Wave Version	6.51.02
Library Type	SLAVE_ENHANCED_232
Device Type	Notification Sensor
Role Type	ROLE_TYPE_SLAVE_SLEEPING_REPORTING
Manufacturer ID	0x0109
Product Type ID	0x2004
Product ID	0x04A4
Frequency Plans	US: 916.00MHz, 908.40MHz
Categories	Sensors
Countries / Regions	United States of America
Documents	Category Description File Manual_Primary_Lang Product or Owner's Manual ZS 6101-5_ZS6102-5 Smoke Detector.pdf
Association Groups	Group Number Maximum Nodes Supported End Point ID Description 1 5 0 Z-Wave Plus Lifeline
Texts	ID Description Value 1 Inclusion Put the Z-Wave™ Interface Controller into “inclusion” mode, and following its instruction to add the ZS6101-5 to your controller. To get in the “inclusion” mode, the distance between detector and controller is suggested to be in one meter. Press the program switch of ZS6101-5 for 1 second at least to be included. After setting, the LED Setting Lighting should go off, if not, please try again. (Please refer to the user manual to understand the program switch location) 2 Exclusion Put the Z-Wave™ Interface Controller into “exclusion” mode, and following its instruction to delete the ZS6101-5 from your controller. Press the program switch of ZS6101-5 for 1 second at least to be excluded. The red LED setting light will flash continuously in Exclusion condition. (Please refer to the user manual to understand the program switch location) 4 Device Wake-Up Press program switch once, the detector will send a Node Information Frame signal first and will also send a “Wake Up Notification” after 3 seconds. (Please refer to the user manual to understand the program switch location)
Supports NWI	Yes
Supports Explorer Frames	Yes