| 2 | Exclusion | 1. Set the controller in remove mode (See your controller’s manual).
2. Place the round magnet at the rounded edge of Strips.
When the LED blinks, move the magnet away. Repeat 3 times in total within 10 seconds.
3. A long LED blink indicates that the remove process was successful. |
| 4 | Device Wake-Up | Wake up Strips manually for Z-Wave communication:
1. Place the round magnet at the rounded edge of Strips.
2. When the LED blinks, move the magnet away.
3. Repeat 3 times in total within 10 seconds. |
| 1 | Inclusion | Strips is delivered in ""auto-add"" mode.
Follow the process below to add Strips in a Z-Wave network.
1. Start the add mode on the Z-Wave controller.
See the controller’s manual.
2. Remove both magnets from Strips. Strips blinks twice to confirm the command and successful addition.
3. A long LED blink indicates that the add process was successful
4. The Z-Wave controller application should now allow you to monitor your Strips sensor status.
5. Move the squared magnet as shown in the picture . Check that the Z-Wave system indicates the status correctly
6. If the Z-Wave system do not respond, it may be needed to change Strips’ notification type.
Manual add:
1. Set the controller to add mode (See your controller’s manual).
2. Place the round magnet at the rounded edge of Strips.
When the LED blinks, move the magnet away. Repeat 3 times in total within 10 seconds.
3. A long LED blink indicates that the add process was successful. |
| 5 | Factory Reset | In order to reset Strips (only possible when the connection to the controller is lost):
1. Place the round magnet at the rounded edge of Strips.
2. When the LED blinks, move the magnet away. Repeat 3 times in total within 10 seconds.
3. After 5 LED blinks, place the magnet at the rounded edge again for 10 seconds.
4. A long LED signal indicates success. |
| 6 | Additional Special Features | Failure message: 5 LED blinks |
