COMMAND_CLASS_POWERLEVEL

Powerlevel

0x73

1

COMMAND_CLASS_BATTERY

Battery

0x80

1

COMMAND_CLASS_SWITCH_BINARY

Switch Binary

0x25

1

COMMAND_CLASS_BASIC

Basic

0x20

1

COMMAND_CLASS_CONFIGURATION

Configuration

0x70

1

COMMAND_CLASS_SECURITY

Security S0

0x98

1

COMMAND_CLASS_VERSION_V2

Version V2

0x86

2

COMMAND_CLASS_DEVICE_RESET_LOCALLY

Device Reset Locally

0x5A

1

COMMAND_CLASS_ZWAVEPLUS_INFO_V2

Z-Wave Plus Info V2

0x5E

2

COMMAND_CLASS_ASSOCIATION_V2

Association V2

0x85

2

COMMAND_CLASS_ASSOCIATION_GRP_INFO

Association Group Info

0x59

1

COMMAND_CLASS_SCENE_ACTIVATION

Scene Activation

0x2B

1

COMMAND_CLASS_FIRMWARE_UPDATE_MD_V2

Firmware Update Meta-Data V2

0x7A

2

COMMAND_CLASS_MANUFACTURER_SPECIFIC_V2

Manufacturer Specific V2

0x72

2

COMMAND_CLASS_NOTIFICATION_V4

Notification V4

0x71

4

Manual_Primary_Lang

Product or Owner's Manual

Battery Quantity

Battery Type

Firmware Updatable

IP (Ingress Protection) Rated

Outdoor Use

2

5

0

Tamper Alarm Report

1

1

0

Z-Wave Plus Lifeline

3

5

0

Power Adaptor(AC) Failure Report

2

Exclusion

REMOVING THE SIREN The Siren must be removed from any existing Z-Wave network before being added into a new Z-Wave network. There are two methods available to remove a device. Removing Mode • Put the existing Z-Wave controller into Removing Mode (please refer to the Z-Wave controller manual). • Within 1.5 seconds, press the learn button 3 times and the Siren will be removed from the existing Z-Wave network. • The Siren is now ready to be added to a new Z-Wave controller.

5

Factory Reset

Factory Reset (Only use this when the existing Z-Wave controller is missing or inoperable). • Turn off battery power switch and disconnect 9V power adaptor (if present). • Press and hold the learn button. • While holding the learn button, power on the Siren (power switch ON and reconnect the 9V power adaptor). Keep holding for 10 seconds to complete the factory reset. • Please note that the existing Z-Wave controller will still retain the Siren’s Z-Wave setting. Please refer to the Z-Wave controller manual on remove procedures. Only use this when the existing Z-Wave controller is missing or inoperable. • The Siren is now ready to be added to a new Z-Wave controller.

1

Inclusion

ADDING THE SIREN This product can be added and operate in any compatible Z-Wave network. All non-battery operated nodes within the network will act as repeaters, regardless of vendor, to increase reliability of the network. Adding steps: • Turn on the battery power switch to activate the pre-inserted batteries. • The Siren will emit a 2-tone beep. • Put the Z-Wave controller into adding or Learning mode (please refer to the Z-Wave controller manual). • Within 1.5 seconds, press the Siren learn button 3 times. • Refer to the operation manual of the Z-Wave controller to complete the learn-in process. • If the Siren has already been added (learnt) into another Z-Wave controller, or if the Siren is unable to be learnt into the current Z-Wave controller, please remove it first (see Removing the siren below) before attempting to add it into the current Z-Wave controller.