Product Network Management Instructions

Z-Wave Network Management & Other Instructions

Procedure	Instructions
Inclusion	Module Inclusion (Adding to Z-wave network) • Connect module to power supply (with temperature sensor connected - if purchased), • auto-inclusion (works for about 5 seconds after connected to power supply) or • press service button S for more than 2 second or • press push button I1 three times within 3s (3 times change switch state within 3 seconds). NOTE: When connecting temperature sensor to module that has already been included, you have to exclude module first. Connect the sensor and re-include the module.
Exclusion	Module Exclusion/Reset (Removing from Z-Wave network) • Connect module to power supply • bring module within maximum 1 meter (3 feet) of the main controller, • enable add/remove mode on main controller • press service button S for more than 6 second or • press push button I1 five times within 3s (5 times change switch state within 3 seconds) in the first 60 seconds after the module is connected to the power supply. By this function all parameters of the module are set to default values and own ID is deleted If service button S is pressed more than 2 and less than 6 second module is excluded, but configuration parameters are not set to default values.
Factory Reset	Please use this procedure only in the event that your network primary controller is missing or otherwise inoperable. If the service button S is pressed for more than 6 seconds the module will be reset to the factory defoult state.