Product Network Management Instructions

Z-Wave Network Management & Other Instructions

Model: Dimmer (DZ6HD)

Z-Wave Certification Number: ZC10-16095221

Procedure	Instructions
Exclusion	When removing a device from a Z-Wave® network best practice is to use the exclusion command found in the Z-Wave® controller. • Enter Programming Mode by holding the top of the paddle for 7 seconds, the Locator LED will blink amber. • Follow directions in the Z-Wave® controller to enter exclusion mode • Tap the top of the paddle one time. The Locator LED will quickly flash green. The Z-Wave® controller will exclude the Decora Smart™ device • The Z-Wave® controller will confirm successful exclusion from the network.
Inclusion	Leviton Decora Smart™ Z-Wave® devices support two methods of inclusion. When using a Z-Wave Plus® certified controller choose Network Wide Inclusion. Network Wide Inclusion: Network Wide Inclusion allows your device to be included into the network using devices already in the network to assist with communication. Work your way from the closest devices to the controller outward. • Enter Programming Mode by holding the top of the paddle for 7 seconds, the Locator LED will blink amber. • Tap the top of the paddle one time. The Locator LED will quickly flash green. • The Decora Smart™ Z-Wave® device is ready to learn into the Z-Wave® network. • Follow directions in the Z-Wave controller to complete the adding process. • Upon successful addition to network the LED will turn off and then blink green 3 times. • If the adding process is not successful the LED will flash red 3 times. Traditional Inclusion: For older controllers Traditional Inclusion is supported. Depending on the age of the controller the controller will need to be 3 to 35 feet from the device when including. • Enter Programming Mode by holding the top of the paddle for 7 seconds, the Locator LED will blink amber. • The Decora SmartTM Z-Wave® device is ready to add to the Z-Wave® network. • Follow directions in the Z-Wave® controller to enter learn mode. • Tap the top of the paddle one time. The Locator LED will quickly flash green. The Z-Wave® controller will begin to pair with the Decora Smart™ device. • Upon successful addition to the network the LED will turn off and then blink green 3 times. • If the adding process is not successful the LED will flash red 3 times.
Factory Reset	When removing a device from a network it is best practice to use the Exclusion process. In situations where a device needs to be returned to factory default follow the following steps. A reset should only be used when a controller is inoperable or missing. • Hold the top of the paddle for a total of 14 seconds. • After the first 7 seconds the LED turns amber. • The Locator LED will quickly flash red/amber after 14 seconds. • Release the top of the paddle and the device will reset.