Product Network Management Instructions

Z-Wave Network Management & Other Instructions

Procedure	Instructions
Exclusion	1. Bring your Z-Wave gateway hub or controller as close to the switch as possible 2. Put your Z-Wave controller in exclusion mode 3. Tap the switch on and off quickly 3 times to complete the exclusion process 4. The device should disappear from your controller's device list
Factory Reset	The switch will be reset to factory defaults only by exclusion using a Z-Wave controller. You may use any certified Z-Wave controller to exclude and reset the switch. This device may not be reset manually when the network’s primary controller is missing or otherwise inoperable. NOTE: All previously recorded activity and custom settings will be erased from the device’s memory.
Inclusion	1. Bring your Z-Wave gateway hub or controller as close to the switch as possible 2. Put your Z-Wave controller in inclusion mode 3. Tap the switch on and off quickly 3 times to finalize the inclusion process 4. A new dimming device should appear on your controller's device list Troubleshooting Tips: If you are unable to include the Z-Wave dimmer to your controller, please try one of the following: - Bring the controller closer to your Z-Wave switch or use a hand-held secondary controller for inclusion - Tap your Z-Wave switch quicker 4 or 5 times once you put the controller in the inclusion mode to ensure the command has gone through - Put your controller in the EXCLUSION mode and tap the switch quickly 3 times, then try adding it to your network again