Product Network Management Instructions

Z-Wave Network Management & Other Instructions

Procedure	Instructions
Factory Reset	All user and network settings will be cleared and the device reset to factory defaults when the device is excluded. Please use this procedure only in the event if the network controller is missing or is otherwise inoperable.
Device Wake-Up	Press the Program SW, the LED will flash one time and ZD2301 will send “Wake Up Notification” after 5 seconds. If ZD2301 received “Wake Up No More Information” command then the ZD2301 will go to sleep or it will wait 10 seconds then go to sleep. It will precede all the commands after sending the “Wake Up Notification”
Inclusion	Put the Z-WaveTM Interface Controller into “inclusion” mode, and following its instruction to add the ZD2301 to your controller. To get in the “inclusion” mode, the distance between sensor and controller is suggested to be one meter. Press the program switch of ZD2301 for sending the NIF. After sending NIF, Z-Wave will send the auto inclusion; otherwise, ZD2301 will go to sleep after 20 seconds.
Exclusion	Put the Z-WaveTM Interface Controller into “exclusion” mode, and following its instruction to delete the ZD2301 from your controller. Press the program switch of ZD2301 for 1 second at least to be excluded.