Product Network Management Instructions

Z-Wave Network Management & Other Instructions

Model: Dome Door/Window Sensor Pro (DMDP1)

Z-Wave Certification Number: ZC10-17065635

Procedure	Instructions
Exclusion	Follow the instructions for your Z-Wave Certified Controller to enter exclusion mode. When prompted by the controller: Remove the SENSOR COVER and the LED Indicator will start blinking red. Press the Button quickly 3 times in a row. The LED Indicator will flash green three times indicating exclusion/disconnection and will then continue flashing red (indicating tamper) until the cover is replaced.
Factory Reset	If needed, the Door/Window Sensor can be reset locally by following these steps. Only do this if your Z-Wave controller is missing or otherwise unreachable. Beware that resetting your device will disconnect it from the system: 1. Remove the Sensor Cover and confirm that your Door/Window Sensor is powered up. 2. Wait for 5 seconds. 3. Move the Magnet and Sensor Base in and out of the closed position 6 times. 4. The LED Indicator will light up red for five seconds when reset successfully. The Door/Window Sensor’s memory will be erased to factory settings.
Inclusion	New Installation 1. For proper inclusion, bring the Door/Window Sensor to the final location where it will be used. 2. Follow the instructions for your Z-Wave controller to enter inclusion mode. 3. Remove the Battery Tab protruding from the Battery Tab Slit. 4. The device will automatically enter inclusion mode for two minutes and the LED Indicator will alternate between green and red. Upon successful inclusion the LED Indicator will flash green three times then stop blinking. Re-Installation 1. For proper inclusion, bring the Door/Window Sensorto the final location where it will be used. 2. Follow the instructions for your Z-Wave controller to enter inclusion mode. 3. Remove the Sensor Cover and the LED Indicator will start blinking yellow. 4. Press the Button quickly 3 times in a row. 5. The device will enter inclusion mode for two minutes and the LED Indicator will alternate between green and red. After successful inclusion, the LED Indicator will flash green three times then blink red until the cover is replaced. *For non Z-Wave Plus networks, please consult the owner’s manual for your primary controller to determine the best method and location for adding the Door/Window Sensor to your Z-Wave network.
Device Wake-Up	Because the Door/Window Sensor is a battery powered device, it wakes up on regular intervals to give battery and other status updates to the controller, as well as to accept configuration settings from the controller. This helps to extend the battery life. The Sensor Cover holds down the Button when installed, and the device can be forced to wake up to submit reports or accept new settings immediately by simply removing the Sensor Cover and then replacing it after. If the device is already included in a system, the LED Indicator will flash Red until the cover is closed.