Product Network Management Instructions

Z-Wave Network Management & Other Instructions

Model: Thermostat (PWLY-7828-A1)

Z-Wave Certification Number: ZC10-17065620

Procedure	Instructions
Factory Reset	Factory Reset Please use Factory Reset only when the network primary controller is missing or otherwise inoperable. To reset to factory defaults, turn the thermostat off by pressing Mode repeatedly until OFF scrolls across the display, then press and hold the down and up Setpoint arrows at the same time for 5 sec. If successful, RESET will scroll across the display and the device will be restored to its default settings. NOTE: If a reset to factory default settings is performed, all settings including Z-Wave configuration parameter values and temperature setpoints will return to default values: Heat: 68 Cool: 78 Measure: Fahrenheit Swing: +/- 1 Multi-stage temp differential: 3 System Type: 2-stage conventional heating & cooling
Exclusion	Z-Wave Exclusion Process To exclude your Thermostat, press and hold Mode for 5 seconds to initiate Z-Wave exclusion process. • DELETE will scroll across the thermostat display once in inclusion mode. • To cancel the exclusion process, press Mode. • To complete exclusion press either of the up/down arrows. • SUCCESS will scroll across the thermostat display once excluded. NOTE: Excluding the thermostat will restore it to the default state for Z-Wave and temperature set points.
Inclusion	Z-Wave Inclusion Process First, be sure your Energy Bridge has power and the green light is illuminated. Follow the in-app instructions along with the steps below to include your Thermostat. To put your thermostat into inclusion mode, press and hold Mode for 5 seconds. • CONNECT will scroll across the thermostat display once in inclusion mode. • SUCCESS will scroll across the thermostat display once included. • FAIL will scroll across the thermostat display if inclusion is unsuccessful, or if process takes longer than 1 minute. See the next page for troubleshooting. To learn more about which Z-Wave command classes this thermostat supports, visit: www.powerley.com/thermostat/command-classes