There are over 4297 interoperable
| Group ID | Group Profile Name | Profile | Maximum Nodes | Description | Endpoint ID | Commands |
|---|---|---|---|---|---|---|
| 1 | 2 | Z-Wave Plus Lifeline • Device Reset Locally (via 3 quick presses of the program switch) • Battery Report (when calculated battery life percentage changes) • Notifications o Water (Type 5; Event Waterleak_Detected) o Heat (Type 4; Event Underheat_Detected) o Heat (Type 4; Event Underheat_Detected) Power (Type 8; Events Power_Applied, Replace_Soon, Replace_Now) | 0 | |||
| 2 | 2 | Basic Set Command ON (default, 0xFF) or OFF (0x00) is sent to the associated nodes to indicate that a Water Alarm is active. This depends on the parameter 4 configuration value. When the water alarm is cleared, one additional report with the opposite value is sent. | 0 | |||
| 3 | 2 | Basic Set Command with value = 0xFF is sent to the associated nodes to indicate that a Temperature High condition has been detected. When the temperature is back in the normal range, one additional report with value = 0x00 is sent. | 0 | |||
| 4 | 2 | Basic Set Command with value = 0xFF is sent to the associated nodes to indicate that a Temperature Low condition has been detected. When the temperature is back in the normal range, one additional report with value = 0x00 is sent. | 0 | |||
| 5 | 2 | Temperature report (Multilevel Sensor) when the temperature has changed (with filtering/hysteresis to avoid continuous transmissions at a transition point). | 0 | |||
| 6 | 2 | Temperature report (Multilevel Sensor) every 5 minutes | 0 | |||
| 7 | 2 | Temperature report (Multilevel Sensor) every 20 minutes | 0 | |||
| 8 | 2 | Temperature report (Multilevel Sensor) every 60 minutes | 0 |