Product Network Management Instructions

Z-Wave Network Management & Other Instructions

Model: Devolo HC Switch FM (MT 02759)

Z-Wave Certification Number: ZC10-18036057

Procedure	Instructions
Exclusion	REMOVAL FROM A Z-WAVE NETWORK • Connect module to power supply • bring module within maximum 1 meter (3 feet) of the main controller, • enable add/remove mode on main controller If push button I1 is pressed three times within 5s (or service button S is pressed more than 2 and less than 6 seconds) module is excluded, but configuration parameters are not set to default values.
Factory Reset	FACTORY RESET • Connect module to power supply • bring module within maximum 1 meter (3 feet) of the main controller, • enable add/remove mode on main controller • press push button I1 five times within 5s (5 times change switch state within 5 seconds) in the first 60 seconds after the module is connected to the power supply or • press service button S (only applicable for 24 V SELV supply voltage) for more than 6 second. By this function all parameters of the module are set to default values and own ID is deleted. *Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Inclusion	AUTOMATICALLY ADDING THE DEVICE TO A Z-WAVE NETWORK 1. Enable add/remove mode on your Z-Wave gateway (hub) 2. Connect the device to the power supply (with the temperature sensor already connected – sold separately). 3. Auto-inclusion will be initiated within 5 seconds of connection to the power supply and the device will automatically enroll in your network MANUALLY ADDING THE DEVICE TO A Z-WAVE NETWORK 1. Enable add/remove mode on your Z-Wave gateway (hub) 2. Connect the device to the power supply (with the temperature sensor already connected) 3. Toggle the switch connected to the I1 terminal 3 times within 3 seconds OR If the device is powered by 24 V SELV supply, press and hold the S (Service) button for at least 2 seconds 4. A new multi-channel device will appear on your dashboard *If connecting the temperature sensor, switch off the power supply and make sure the device is excluded from your network BEFORE connecting the sensor. Make sure the device is excluded from your network before connecting the temperature sensor. Switch off the power supply, connect the temperature sensor, and re-include the device to your network.