Product Network Management Instructions

Z-Wave Network Management & Other Instructions

Model: FIBARO Double Switch 2 (FGS-223)

Z-Wave Certification Number: ZC10-18015920

Procedure	Instructions
Additional Special Features	Z-Wave Plus communication protocol Active power and energy metering functionality Z-Wave range tester LED diode
Inclusion	1) Switch off the mains voltage (disable the fuse). 2) Make sure the Switch 2 is within the direct range of your Z-Wave controller. 3) Connect the device in accordance with one of the diagrams included in the manual. 4) After verifying correctness of the connection switch on the mains voltage. 5) Identify the S1 switch or the B-button (located on the device’s housing). 6) Set the main controller in (security/non-security) add mode (see the controller’s manual). 7) Quickly, three times press the S1 switch or the B-button. 8) Wait for the adding process to end. 9) Successful adding will be confirmed by the Z-Wave controller’s message.
Exclusion	1) Make sure the Switch 2 is within the direct range of your Z-Wave controller. 2) Identify the S1 switch or the B-button (located on the device’s housing). 3) Set the main controller in remove mode (see the controller’s manual). 4) Quickly, three times press the S1 switch or the B-button. 5) Wait for the removing process to end. 6) Successful removing will be confirmed by the Z-Wave controller’s message.
Device Wake-Up	The FIBARO Double Switch 2 is powered with the mains voltage so it is always awake.
Factory Reset	Reset procedure allows to restore the device back to its factory settings, which means all information about the Z-Wave controller and user configuration will be deleted. In order to reset the device: 1) Switch off the mains voltage (disable the fuse). 2) Remove the Switch 2 from the wall switch box. 3) Switch on the mains voltage. 4) Press and hold the B-button to enter the menu. 5) Wait for the visual LED indicator to glow yellow. 6) Quickly release and click the B-button again. 7) After few seconds the device will be restarted, which is signalled with the red LED indicator colour. Use reset procedure only if the primary controller is missing or inoperable.