Z-Wave Products

There are over 4399 interoperable Z-Wave products throughout the world, and over 94 million Z-Wave products have been sold since our beginnings in 2001. All of them work together regardless of brand, because they're all based on the common Z - Wavestandard.Browse our Product Finder to see what Z -Wave can do for you.

Z-Wave Configuration Capabilities

Model: Roller shutter controller (PAN08-3)

Z-Wave Certification Number: ZC10-18046091


Parameter Number

Parameter Size

Parameter Name

Parameter Values

1 2 Watt Meter Report Period 1 to 32767
(Default)
5*720s=3600s=1 hour

Parameter Number

Parameter Size

Parameter Name

Parameter Values

2 2 KWH Meter Report Period 1 to 32767
(Default)
6*10min= 1 hour

Parameter Number

Parameter Size

Parameter Name

Parameter Values

3 2 Threshold of current for load caution 10 to 500
(Default)
500*0.01A=5A

Parameter Number

Parameter Size

Parameter Name

Parameter Values

4 2 Threshold of KWh for Load Caution 1 to 10000
(Default)
10000*1KWh=10000KWh

Parameter Number

Parameter Size

Parameter Name

Parameter Values

5 1 External switch type 1 One Push Button: When the configuration setting is One Push Button, only S1 input will be valid. The control moving commands can be accepted in this switch type while the shutter is moving. In this switch type, the inclusion/exclusion/reset/association function can also be fulfilled by pressing S1 just like the operation of include button. When S1 is short pressed, the shutter will move up toward TOP(0xFF). While in this moving S1 is short pressed again, the shutter will stop moving. A third short pressing of S1 will move the shutter down toward BOTTOM(0x00). While in this moving S1 is short pressed again, the shutter will stop moving. And so on… Inverting direction and stopping.
  2
(Default)
Two Push Button: (The default setting is Two Push Button (2)) If this setting is configured as Two Push Button, S1 and S2 input will be valid, but will not accept pressing S1and S2 at the same time. In this switch type, the inclusion/exclusion/reset/association function can also be fulfilled by pressing S1 or S2 just like the operation of include button. When S1 is pressed and hold more than 1.5 seconds, the shutter will move up toward TOP(0xFF), and the shutter will stop moving when S1 is released. When S2 is pressed and hold more than 1.5 seconds, the shutter will move down toward BOTTOM(0x00), and the shutter will stop moving when S2 is released. When S1 is short pressed, the shutter will move up toward TOP(0xFF). While in this moving short pressed S1 again, the shutter just keep moving up toward TOP(0xFF). The easy way to stop this moving is short pressing S2. When S2 is short pressed, the shutter will move down toward BOTTON(0x00). While in this moving short pressed S2 again, the shutter just keep moving down toward BOTTON(0x00). The easy way to stop this moving is short pressing S1.

Parameter Number

Parameter Size

Parameter Name

Parameter Values

6 1 Level Report mode 1 Mode 1 : In 5 seconds period after controlled by a moving command, it will report the destination level when received request command. Out of the 5 seconds period, it will report the actual level of the shutter when received request command.
  2
(Default)
Mode 2 : Whenever the shutter move pass a 10 percent level, it will auto report the level to Group 1 node.