Product Network Management Instructions

Z-Wave Network Management & Other Instructions

Procedure	Instructions
Factory Reset	1. Place the device into ON mode (upper position of Operating Mode Switch) 2. Press and hold the programming button. 3. While holding programming button, place device into OFF mode (middle position of Operating Mode Switch). 4. While holding programming button, place device back into ON mode (upper position of Operating Mode Switch). 5. After three (3) seconds, release programming button. Green LED will flash 3 times when completed successfully. Note: This should only be used in the event your network’s primary controller is missing or otherwise inoperable.
Exclusion	1. Follow the instructions for your Z-Wave certified controller to remove a device from the Z-Wave network. 2. Once the controller is ready to remove your device press and release the programming button to remove it from the network.
Inclusion	1. Follow the instructions for your Z-Wave certified controller to add a device to the Z-Wave network. 2. Once the controller is ready to add your device, press and release the programming button to add it to the network. If prompted by the controller to enter the S2 security code, refer to the QR code/security number on the back of the box, or the QR code label on the product. 3. Once your controller has confirmed that the device has been added, refresh the Z-Wave network to optimize performance.