Product Network Management Instructions

Z-Wave Network Management & Other Instructions

Model: HC Shutter FM (MT 02761)

Z-Wave Certification Number: ZC10-18076191

Procedure	Instructions
Exclusion	Module Exclusion (Removing from Z-Wave network) • Connect module to power supply • bring module within maximum 1 meter (3 feet) of the main controller, • enable add/remove mode on main controller If push button I1 is pressed three times within 3s (or service button S is pressed more than 2 and less than 6 seconds) module is excluded, but configuration parameters are not set to their default values.
Inclusion	Module Inclusion (Adding to Z-wave network) • Connect module to power supply (with temperature sensor connected - if purchased), • auto-inclusion (works for about 5 seconds after connected to power supply) or • press push button I1 three times within 3s (3 times change switch state within 3 seconds) or • press service button S (only applicable for 24 V SELV supply voltage) for more than 2 second. NOTE1: For auto-inclusion procedure, first set main controller into inclusion mode and then connect module to power supply. NOTE2: When connecting temperature sensor to module that has already been included, you have to exclude module first. Switch off power supply, connect the sensor and re-include the module.
Factory Reset	• press push button I1 five times within 3s (5 times change switch state within 3 seconds) in the first 60 seconds after the module is connected to the power supply or • press service button S (only applicable for 24 V SELV supply voltage) for more than 6 second. By this function all parameters of the module are set to their default values and the ID of the device is deleted. NOTE: Please use this procedure only when the network primary controller is missing or otherwise inoperable. NOTE: If the module is included with parameters 71 with value different to default and module reset is done, wait at least 30s before next inclusion