Product Network Management Instructions

Z-Wave Network Management & Other Instructions

Model: 1 Scene Z-Wave controller (34172/ZW5304)

Z-Wave Certification Number: ZC10-18096225

Procedure	Instructions
Controller Inclusion	This step will add devices to a Scene button. You must complete all steps in this box within 20 seconds or the controller will time out. Please familiarize yourself with these steps before you begin programming. 1. Press and hold the ""^"" and ""v"" buttons for three (3) seconds. The LED will slowly flash every second. 2. Press and release the ""^"" button. The LED will quickly flash for 20 seconds. 3. Locate the manual/program button on the Z-Wave module/switch you are adding to the scene controller. Follow the instructions for your Z-Wave device to add it to the scene (same as adding to a hub). The LED will quickly flash. 4. Using the manual/program button on the module/switch, adjust the light to your desired level of brightness. The LED will quickly flash. 5. Press and release the ""v"" button to exit programming. The LED will turn on for two (2) seconds.
Controller Exclusion	1. Press and hold the ""^"" and ""v"" buttons for three (3) seconds. The LED will slowly flash every second. 2. Press and hold the ""^"" and ""v"" buttons for three (3) seconds. The LED will quickly flash for 20 seconds. 3. Press and release the manual/program button on the Z-Wave module/switch to remove it from network. The LED will turn on for two (2) seconds.
Device Wake-Up	1. Press and hold the ""^"" and ""v"" buttons for three (3) seconds. The LED will slowly flash every second. 2. Press and hold the ""v"" button for three (3) seconds. The LED will quickly flash. 3. Press and release the ""^"" button. The LED will light for two (2) seconds. If the setup is successful, the keypad will stay awake for 30 seconds. During sleep mode, the controller will sleep again within two (2) seconds after any button is pressed.
Learn Mode (adding another controller)	This will copy the network and device information from your existing hub/primary controller to the scene controller, making it a secondary controller. 1. Following the manufacturers guidelines to place your existing primary controller or hub into inclusion mode. 2. Press and hold the ""^"" and ""v"" buttons for three (3) seconds. The LED will slowly flash every second. 3. Press and hold the ""^"" button for three seconds. The LED will flash for ten (10) seconds. 4. Press and release the ""v"" button to set the device as a receiver. The LED will slowly flash every second. If network transfer was successful, the LED will turn on for two (2) seconds.
Factory Reset	Note: All Z-Wave device connections and scenes will be lost in the reset. If the controller is setup as the primary controller after performing a reset, each Z-Wave device that was previously in the network will need to be individually reset or excluded from the network before it can be included again. The steps for resetting and reconnecting each smart device differ, please refer to the device manufacturer for reset instructions. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable. 1. Press and hold the ""^"" and ""v"" buttons for three (3) seconds. The LED will slowly flash every second. 2. Press and hold the ""v"" button for three (3) seconds. The LED will quickly flash three (3) times. 3. Press and release the ""v"" button. The LED will flash three (3) times if successful.