Product Network Management Instructions

Z-Wave Network Management & Other Instructions

Model: Slim Smart Door/Window Sensor (43973/ZW6305)

Z-Wave Certification Number: ZC10-19016363

Procedure	Instructions
Inclusion	Automatic mode 1. Follow the instructions for your Z-Wave certified controller to add the sensor in the Z-Wave network. 2. Once the controller is ready to add your sensor, slide the battery door down and remove (if not mounted to door or window). 3. Remove the plastic battery tab. This activates the sensor and starts the auto-add process. The red LED will begin to flash quickly as it searches for a network. The sensor will attempt to search for a network for two minutes, after which, it will time out. 4. The red LED will continue to flash quickly after it locates a network – the controller’s app will indicate if it has discovered the sensor. If prompted by the controller to enter the S2 security code, refer to the QR code/security number on the back of the box, or the QR code label on the product. Enter the 5-digit code. 5. The red LED will activate for 3 seconds to confirm the sensor has been added in the network. Manual mode 1. Follow the instructions for your Z-Wave certified controller to add the sensor in the Z-Wave network. 2. Once the controller is ready to add your sensor, ensure battery is installed with the correct polarity in the sensor and the battery tab has been removed. 3. Press and release the programming button. This starts the manual add process. The red LED will begin to flash quickly as it begins the add process. 4. The red LED will activate for 3 seconds to confirm the sensor has been added in the network. 5. The controller’s app will indicate if it has discovered the sensor. If prompted by the controller to enter the S2 security code, refer to the QR code/security number on the back of the box, or the QR code label on the product. Enter the 5-digit code.
Factory Reset	1. Press the programming button 10 times within 6 seconds (interval between presses of the button cannot be longer than 1 second). 2. The red LED will activate for 2 seconds, followed by 3 quick flashes. - Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Exclusion	1. Follow the instructions for your Z-Wave certified controller to remove the sensor from the Z-Wave network. 2. Once the controller is ready to remove your sensor, press and release the programming button on the sensor 1 time to remove it from the network. 3. The red LED will blink 5 times to indicate it has been removed.