Product Network Management Instructions

Z-Wave Network Management & Other Instructions

Model: Heatit Z-Dim (Z-Dim)

Z-Wave Certification Number: ZC10-19106778

Procedure	Instructions
Factory Reset Procedure	By pressing and holding the main button for 20 seconds, the dimmer will perform a complete factory reset. The connected light source will blink once and go in the ”OFF” state if successfully reset. NB! Please use this procedure only when the primary controller/gateway is missing or otherwise inoperable.
Where to find S2 DSK on product	The Z-Wave DSK can be found in the QR-Code and is located in 3 locations; 1. Box of the product. 2. On physical product, placed on the metal frame. 3. On the PCB.
Classic Exclusion	Remove Please refer to your primary controller manual on how to enter remove mode. The device can only be removed from the network if the primary controller is in remove mode. When the primary controller is set to remove modus press the main button on the dimmer 6 times in a rapid sequence. When the device is removed from the network, the device will revert to factory default settings.
Controller Classic Inclusion	Add Please refer to your primary controller manual on how to enter add mode. The device can only be added to the network if the primary controller is in add mode. When the primary controller is set to add modus press the main button on the dimmer 6 times in a rapid sequence. If the device already belongs to a network, follow the removing process before adding it in your network. Otherwise, the adding of this device will fail.
Other Special Features	Paragraph 8 "Power Metering" configuration guide.
Controller Classic Exclusion	Remove Please refer to your primary controller manual on how to enter remove mode. The device can only be removed from the network if the primary controller is in remove mode. When the primary controller is set to remove modus press the main button on the dimmer 6 times in a rapid sequence. When the device is removed from the network, the device will revert to factory default settings.
Classic Inclusion	Add Please refer to your primary controller manual on how to enter add mode. The device can only be added to the network if the primary controller is in add mode. When the primary controller is set to add modus press the main button on the dimmer 6 times in a rapid sequence. If the device already belongs to a network, follow the removing process before adding it in your network. Otherwise, the adding of this device will fail.