Product Network Management Instructions

Z-Wave Network Management & Other Instructions

Model: Z-Wave Smart Motor Actuator (IoTx-z-actmotor001)

Z-Wave Certification Number: ZC10-19096736

Procedure	Instructions
Where to find S2 DSK on product	page 1：The encryption modes that the in-wall shutter module supports are S0, S2 authenticated. page 7: SUPPORTED COMMAND CLASS
Classic Inclusion	Make sure connecting module to power supply and module has not joined Z-Wave network (if module joined any other Z-Wave network, please refer to the clauses “Exclude device from a Z-Wave network”). First, set primary controller/gateway into inclusion mode. And press 'Button L' 3 times, LED starts to flash slowly for 10 seconds, during the flash, don’t press 'Button L' 3 times again, because it will cancel your last operation. Until LED is on for 3 seconds, means success. If module does not find a Z-Wave network within 10 seconds after join network function trigger, please try again. After joined Z-Wave network, please wait for a while until the app showing device is included. Then you can start enjoying with our module.
Classic Exclusion	Method 1: Factory Reset. Method 2: First, set primary controller/gateway into exclusion mode. And press 'Button L' 3 times, LED started to flash slowly for 10 seconds, during the flash, don’t press 'Button L' 3 times again, because it will cancel your last operation. Until LED is on for 3 seconds, means success.
Controller Classic Inclusion	Make sure connecting module to power supply and module has not joined Z-Wave network (if module joined any other Z-Wave network, please refer to the clauses “Exclude device from a Z-Wave network”). First, set primary controller/gateway into inclusion mode. And press 'Button L' 3 times, LED starts to flash slowly for 10 seconds, during the flash, don’t press 'Button L' 3 times again, because it will cancel your last operation. Until LED is on for 3 seconds, means success. If module does not find a Z-Wave network within 10 seconds after join network function trigger, please try again. After joined Z-Wave network, please wait for a while until the app showing device is included. Then you can start enjoying with our module.
Controller Classic Exclusion	Method 1: Factory Reset. Method 2: First, set primary controller/gateway into exclusion mode. And press 'Button L' 3 times, LED started to flash slowly for 10 seconds, during the flash, don’t press 'Button L' 3 times again, because it will cancel your last operation. Until LED is on for 3 seconds, means success.
Other Special Features	Module is learning motor running position automatically each time when it’s pot on power supply.Tap Button R two times, learning function start, motor is running automatically to the up/down limit. During learning, LED light is flash slowly, until LED blink 2 seconds means success. During learning, press Button R to quit learning.
Factory Reset Procedure	Please use this procedure only when the network primary controller is missing or otherwise inoperable. Hold Button L for 10 seconds, LED will flash slowly until flash fast for 2 seconds means success. After reset, module is exclude of Z-Wave network, please include again and learn motor again.
Learn Mode (adding another controller) Procedure	Module is learning motor running position automatically each time when it’s pot on power supply.Tap Button R two times, learning function start, motor is running automatically to the up/down limit. During learning, LED light is flash slowly, until LED blink 2 seconds means success. During learning, press Button R to quit learning.