Product Network Management Instructions

Z-Wave Network Management & Other Instructions

Model: ECO-DIM.07 Z-Wave LED dimmer (ECO-DIM.07 Z-Wave)

Z-Wave Certification Number: ZC10-20036885

Procedure	Instructions
Where to find S2 DSK on product	You can scan the QR code with an android Phone. For example, the QR code may be scanned by the application provided with your SmartStart compatible Z-Wave controller. (The data for each dimmer is different). Note: If your controller does not support SmartStart inclusion, please refer to the manual for your controller for non-SmartStart inclusion.
Classic Inclusion	Product Classic Inclusion Description 1. Set primary controller/gateway into inclusion mode (If you don’t know how to do this, please refer to your primary controller’s manual on how to turn your controller into inclusion mode). 2. Short press 2 times the reset button, it will set the dimmer controller into inclusion mode.25 seconds timeout if there is no reply from the Z-Wave primary controller, repeat the operation. 3. The dimmer controller will be added to the Z-Wave network.
Classic Exclusion	1. Set primary controller/gateway into exclusion mode (If you don’t know how to do this, please refer to your primary controller’s manual on how to turn your controller into exclusion mode). 2. Short press 2 times the reset button, it will set the dimmer controller into exclusion mode (The dimmer controller already exists a Z-Wave network). 25 seconds timeout if there is no reply from the Z-Wave primary controller, repeat the operation. 3. The dimmer controller will be removed from the Z-Wave network. Note: The Dimmer will start SmartStart Inclusion when it is removed from a Z-wave network.
Factory Reset Procedure	Press and hold down reset button for over 4 seconds, the dimmer controller will be reset to factory defaults. Note: This procedure should only be used when the primary controller is inoperable. Reset Dimmer controller to factory default settings will sets the Dimmer to not in z-wave network state, delete the Association setting and restore the Configuration setting to the default. The Dimmer controller will start SmartStart Inclusion when it is reset.