Product Network Management Instructions

Z-Wave Network Management & Other Instructions

Model: Heatit Z-TRM3 (Z-TRM3)

Z-Wave Certification Number: ZC10-20036889

Procedure	Instructions
Where to find S2 DSK on product	The Z-Wave DSK can be found in the QR-Code and is located in 3 locations; 1. On the product box. 2. On the physical product, placed on the black plastic underneath the front. 3. On the PCB internally.
Classic Exclusion	Remove. The primary controller/gateway has a mode for removing devices. Please refer to your primary controller manual on how to set the primary controller in remove mode. The device may only be removed from the network if the primary controller is in remove mode. When the device is removed from the network, it will NOT revert to factory settings. Removing mode is indicated on the display by rotating LED segments on the display. This lasts until the timeout occurs after 90 seconds, or until the module has been added/removed in the network. Confirmation will show Inc/EcL on the display. Exit programming mode by choosing ESC in the menu. Your thermostat is now ready for use with default settings. NB! When the thermostat is removed from the gateway, the parameters are not reset.
Other Special Features	Chapter 8. Principles of regulation Chapter 11. Standby and main screen Chapter 12. Choice of sensor Chapter 13. Selecting the right value for your external floor sensor Chapter 14. Calibration Chapter 17. Min/Max temperature settings Chapter 18.1 Display on/off Chapter 18.2 Childlock
Factory Reset Procedure	By pressing buttons Right and Center (down and confirm) for 20 seconds, the thermostat will perform a complete factory reset. NB! Please use this procedure only when the primary controller/gateway is missing or otherwise inoperable. The device will display rES for 10 seconds while performing a factory reset. When rES no longer is displayed, the thermostat has been reset.
Classic Inclusion	Add. The primary controller/gateway has a mode for adding devices. Please refer to your primary controller manual on how to set the primary controller in add mode. The device may only be added from the network if the primary controller is in add mode. There are two ways to add the Heatit Z-TRM3 to a Z-Wave network. METHOD 1: STANDARD (MANUAL) 1. Press Center (confirm) for 10 seconds. The display will show OFF. 2. Press Right (down) 5 times until you see Con on the display. 3. Start the add/remove device process in your primary controller. 4. Start the add/remove mode in the Heatit Z-TRM3 by pressing Center (confirm) for approximately 2 seconds. Adding mode is indicated on the display by rotating LED segments on the display. This lasts until the timeout occurs after 90 seconds, or until the module has been added in the network. Confirmation will show Inc/EcL on the display. Exit programming mode by choosing ESC in the menu. Your thermostat is now ready for use with default settings. METHOD 2: SMARTSTART (AUTOMATIC) SmartStart enabled products can be added into a Z-Wave network by scanning the Z-Wave QR-Code present on the product with a controller providing SmartStart inclusion. No further action is required and the SmartStart product will be added automatically within 10 minutes of being switched on in the network vicinity.