Product Network Management Instructions

Z-Wave Network Management & Other Instructions

Model: The Heat Controller (FGT-001)

Z-Wave Certification Number: ZC10-20026868

Procedure	Instructions
Wake-Up Procedure	FIBARO Heat Controller is a FLiRS device. The FLiRS device alternates between sleep mode and a partially awake mode in which it is listening beam signal. When device receives this beam, it immediately fully wakes up and then communicates with the controller or other Z-Wave device.
Where to find S2 DSK on product	Page 5: If you are adding in S2 authenticated mode, type in the device pin code (underlined part of the public key on the label).
Factory Reset Procedure	Please use this procedure only when the network primary controller is missing or otherwise inoperable. Reset procedure allows to restore the device back to its factory settings, which means all information about the network and user configuration will be deleted. To perform factory reset: 1. Use the included key to press and hold the button. 2. Release the button when you see yellow LED colour. 3. Click the button to confirm the selection. 4. After finishing resetting the device will be put in Standby Mode. Click the button to activate it again.
Classic Inclusion	To add the device to the Z-Wave network: 1. Make sure the device is within the direct range of your Z-Wave controller. 2. Set the main controller in (security/non-security) add mode. 3. Use the included key to quickly triple click the button on the thermostatic head. 4. The LED ring will start blinking white. 5. If you are adding in S2 authenticated mode, type in the device pin code (underlined part of the public key on the label). 6. Wait for the adding process to end. 7. Successful adding will be confirmed by the Z-Wave controller.
Classic Exclusion	To remove the device from the Z-Wave network: 1. Make sure the device is within the direct range of your Z-Wave controller. 2. Set the main controller into remove mode. 3. Use the included key to quickly triple click the button on the thermostatic head. 4. The LED ring will start blinking white. 5. Wait for the removing process to end. 6. Successful removing will be confirmed by the Z-Wave controller.