Product Network Management Instructions

Z-Wave Network Management & Other Instructions

Model: Bypass Door Window Sensor Z-Wave 700 (7AA-SS-VE-C0)

Z-Wave Certification Number: ZC12-20030038

Procedure	Instructions
Where to find S2 DSK on product	on the side of product
Classic Exclusion	1. Power on your Door Sensor, and let the Z-Wave primary controller into remove/exclusion mode. 2. Trigger this action. 3. LED will flash red during the exclusion, and then solid red for 2 seconds to indicate that the exclusion is successful, otherwise the LED will solid green for 2 seconds in which you need to repeat the process form step 2.
Dynamic Capabilities	pls chekc the user manual on page 9
Notice of Capability Rediscovery Needed	NA
Factory Reset Procedure	Reset Contact Sensor to factory default. NOTE: 1. Triggering this action, the red LED will be accelerate blink in 5 seconds. After 5 seconds, the red LED will remain on until the key is released. Contact Sensor will send “Device_Reset_Locally” to the main controller and exclude from the Z-Wave network when the button is released, this procedure will reset the sensor to factory default. 2. Please use this procedure only when the network primary controller is missing or otherwise inoperable. 3. When not in the network, triggering this action, the red LED will be accelerate blink in 5 seconds. After 5 seconds, the red LED will remain on until the key is released, this procedure will reset the sensor to factory default.
Classic Inclusion	1. Power on your Door Sensor, set your Z-Wave controller into add/inclusion mode. 2. Trigger this action 3. LED will flash green during the inclusion, and then solid green for 2 seconds to indicate the inclusion is successful, otherwise the LED will solid red for 2 seconds in which you need to repeat the process form step 2
Wake-Up Procedure	Power on: In the network: Send Battery report and Wake up notification, the LED will solid green within 1 second. Not in the network: Only the LED will blink red for three times and then off. Short press button one time : In the network: Send Wake up notification, and green LED will fast blink when sending data, and turn off once send completed. But if it don’t receive ack from gateway, the green led will blink for 10 seconds. Not in the network: NOP