Product Network Management Instructions

Z-Wave Network Management & Other Instructions

Model: Era Inn Edge S AC ZW BD (E EDGE SI 620 AC ZWA BD)

Z-Wave Certification Number: ZC10-20056911

Procedure	Instructions
Classic Exclusion	1. Make sure the product is powered. 2. Set your main controller into its 'remove product' mode. Refer to its manual if you are unsure of how to perform. 3. Quickly, triple click any one of the buttons. 4. Wait for the removing process to end. 5. Confirm the removing result. Successful removing will be confirmed by the Z-Wave controller’s message or LED status. If removing is successful, Green LED will become flash slowly. If its Red LED becomes solid for 3s and then off, it indicates removing is unsuccessful. Repeat the above steps or contact us for further support if needed.
Where to find S2 DSK on product	QR/PIN code can be found on the product.
Classic Inclusion	1. Power the product. 2. Set your main controller into its 'add product' mode. Refer to its manual if you are unsure of how to perform. 3. Quickly, triple click any one of the buttons. Green LED will flash quickly which indicates entering inclusion mode, and Node Info will be issued for adding. 4. If your controller supports S2 security, and you want to add the product into S2 Authenticated network, please scan the QR code or enter the PIN code (the underlined 5-digits of the DSK) when prompted. [IMPORTANT] QR/PIN code can be found on the product. A full DSK string can be found on the packaging. 5. Wait for the adding process to end. 6. Confirm the adding result. Successful adding will be confirmed by the Z-Wave controller’s message or LED status. If adding is successful,Green LED will become solid for 3s and then off. If its Red LED become solid for 3s and then Green LED flash slowly, it indicates adding is unsuccessful. The product will auto-reset and then activate SmartStart. Repeat the above steps or contact us for further support if needed. Note: The classic manually inclusion will exit if triple click any one of buttons during the adding process. Its Red LED will become solid for 3s and then Green LED flashes slowly. The product will auto-reset and activate SmartStart
Factory Reset Procedure	Reset procedure allows to restore the product back to its factory settings, which means all information about the Z-Wave controller and user configuration will be deleted. 1. Make sure the product is powered. 2. Press and hold any one of the buttons for at least 20s, and then Factory Reset is performed. The product will issue a Device Reset Locally Command via its Lifeline to notify the Lifeline destination that the product has been reset to its factory default state. And it will perform the reset operation regardless of whether or not the delivery of the Device Reset Locally Notification is successful. 3. Pay attention to the color change of the indicator light. After few seconds the product will be reset and restarted, which is signaled with the slowly flash Green LED indicator color.