Product Network Management Instructions

Z-Wave Network Management & Other Instructions

Model: DIMMER 2 400W (DIMMER 2 400W)

Z-Wave Certification Number: ZC10-20076932

Procedure	Instructions
Factory Reset Procedure	Press and hold down the action button for over 10 seconds, the dimmer will be reset to factory defaults, the load brightness will be restored to 50%. Note: Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Classic Inclusion	1. Set primary controller/gateway into inclusion mode (Please refer to your primary controller’s manual on how to turn your controller into inclusion). 2. Power on the in-wall dimmer and set it into inclusion mode. There are two methods to set the in-wall dimmer into inclusion mode: 1)Repower on the dimmer, it will be set into inclusion mode automatically, and waiting to be included. 2)Triple press the action button on the dimmer, it will set the dimmer into inclusion mode. The connected light will stay solid on for 3 seconds to indicate successful inclusion.
Classic Exclusion	There are two exclusion methods: Method 1: Exclusion from the primary controller/gateway as follows: 1. Set the primary controller/gateway into exclusion mode (Please refer to your primary controllers manual on how to set your controller into exclusion). 2. Triple press the action button, the dimmer will be set to exclusion mode, and waiting to be excluded, then the dimmer will be excluded from the network. Method 2: Factory reset the dimmer will force it to be excluded from a network. (please refer to the part “Factory Reset” of this manual) Note: Factory reset is not recommended for exclusion, please use this procedure only if the primary controller/gateway is missing or otherwise inoperable.