Product Network Management Instructions

Z-Wave Network Management & Other Instructions

Model: Portable Remote, Simple Controller, 2 Button (53829/ZW5313)

Z-Wave Certification Number: ZC12-20090119

Procedure	Instructions
Where to find S2 DSK on product	When prompted, scan the QR code on the back of the remote or type the 5-digit pin code located on the back of the remote. If prompted by the controller to enter the S2 security code, refer to the QR code/security number on the side of the box or the QR code label on the product (see Figure 1). Enter the 5-digit PIN code.
Classic Inclusion	1. Follow the instructions for your Z-Wave certified hub to add a device to the Z-Wave network. 2. Once the hub is ready to add your device, press and hold either button for three seconds. 3. The LED will flash two times when the remote sends add notification (NIF). 4. The LED will keep lighting up for one minute if inclusion is successful.5. Following the instructions for your Z-Wave certified hub, assign actions for each button press. An action can be many combinations of scenes, groups or events, and is greatly dependent on the hub capabilities.
Classic Exclusion	1. Follow the instructions for your Z-Wave certified hub to remove a device from the Z-Wave network. 2. Once the hub is ready to remove your device, press and hold either button for three seconds. 3. The LED will flash two times when the remote sends remove notification (NIF).
Controller Inclusion	Adding your remote to a Z-Wave network 1. Follow the instructions for your Z-Wave certified hub to add a device to the Z-Wave network. 2. Once the hub is ready to add your device, press and hold Button 1 for 3 seconds. 3. The LED will flash two (2) times when the remote sends add notification (NIF). NOTE: Some Hubs will require an additional step for secure inclusion, when prompted scan the QR code on the back of the remote, or type in the 5-digit pin code located on the back of the remote.
Controller Exclusion	Removing your remote from a Z-Wave network 1. Follow the instructions for your Z-Wave certified hub to remove a device from the Z-Wave network. 2. Once the hub is ready to remove your device, press and hold Button 1 for 3 seconds. 3. The LED will flash two (2) times when the remote sends remove notification (NIF).
Wake-Up Procedure	1. Press and hold Button 1 for 3 seconds. 2. The LED will flash two (2) times.
Factory Reset Procedure	1. Press and release Button 1 ten times quickly. All button presses must be within 6 seconds. 2. The LED will flash five (5) times when completed successfully.