Product Network Management Instructions

Z-Wave Network Management & Other Instructions

Model: Z-WAVE 700 Motion Sensor Pet Immunity (7CA-SS-VE-A0)

Z-Wave Certification Number: ZC12-21090310

Procedure	Instructions
Other Special Features	NA
Dynamic Capabilities	NA
Notice of Capability Rediscovery Needed	NA
Where to find S2 DSK on product	on the saide of the product
Classic Inclusion	Add the Motion Sensor into the Z-Wave network: 5. Power on your Motion Sensor, and let your Z-Wave controller into add/inclusion mode. 6. 3 consecutive clicks in 1.5 seconds, the Motion Sensor will send out a node info security CC in command class list (Security inclusion), the LED will be fast blink ,the timeout is 20-40 seconds; 7. If the inclusion is successful, the LED will be turn on within 2 seconds. If failed, LED will be turn off forever, and please repeat the steps in above.
Classic Exclusion	Remove Motion Sensor from a Z-Wave network: 1. Power on your Motion Sensor, and let the Z-Wave primary controller into remove mode. 2. 3 consecutive clicks in 1.5 second, the LED will be fast blink ,the timeout is 20-40 seconds; 3. If Motion Sensor has been successfully removed from your Z-Wave network, the LED will be turn on 2 seconds. If failed, LED will be turn off forever, and please repeat the steps in above.
Wake-Up Procedure	In the network: Send Wake up notification, and LED will fast blink when sending data, send over then the LED turn off.
Factory Reset Procedure	Reset Motion Sensor to factory default. 1. Triggering this action, in 5 seconds LED will be accelerate blink. After 5 seconds, the LED will remain on until the key is released. Motion Sensor will send “Device_Reset_Locally” to the main controller and exclude from the Z-Wave network when the button is released, this procedure will reset the sensor to factory default. 2. Please use this procedure only when the network primary controller is missing or otherwise inoperable. 3. When not in the network, triggering this action, in 5 seconds LED will be accelerate blink red. After 5 seconds, the LED will remain on red until the key is released. this procedure will reset the sensor to factory default.