Product Network Management Instructions

Z-Wave Network Management & Other Instructions

Procedure	Instructions
Where to find S2 DSK on product	Under Z-Wave Control
Classic Inclusion	1. Insert the battery. 2. Place the sensor near the location where it will be mounted. 3. Initiate inclusion in the Z-Wave hub. 4. Click the Z-Wave button on the sensor with a paperclip once. 5. The LED indicator will blink red to signal communication and green once the PIN is entered, then turn off to confirm inclusion.
Classic Exclusion	1. Initiate EXCLUSION and click the Z-Wave button on the sensor once. 2. Make sure the battery cover is closed tightly when adding the sensor. 3. Click the Z-Wave button once every 15 seconds for 2 minutes after the sensor joins the network to keep it awake so it can fully configure. 4. Click the Z-Wave button on the sensor 6-7 times quickly when adding it.
Wake-Up Procedure	Press and release the Z-Wave button once to wake the device up. The LED indicator will flash once (blue or orange).
Factory Reset Procedure	If your primary controller is missing or inoperable, you may need to reset the device to factory settings. To complete the reset process manually, remove the back cover to trigger tamper switch. Press and release the Z-Wave button using a paperclip 10 TIMES quickly (within 10 seconds).