Product Network Management Instructions

Z-Wave Network Management & Other Instructions

Model: Venture WISE Window Sensor (FGDW-002)

Z-Wave Certification Number: ZC10-22127118

Procedure	Instructions
Factory Reset Procedure	Resetting the Sensor: Reset procedure allows to restore the device back to its factory settings, which means all information about the Z-Wave controller and user configuration will be deleted. In order to reset the device: 1. Open the cover. 2. Remove the battery. 3. Install the battery while holding both TMP buttons. 4. Visual LED indicator will be flashing slowly for 5 seconds - keep holding the buttons. 5. Release one button when the LED indicator starts flashing quickly. 6. Click released button once to confirm launching of reset procedure. 7. Wait a few seconds until a long blink of the LED indicator. Do not remove the battery. 8. Visual LED indicator will blink 5 times quickly to confirm the reset.
Wake-Up Procedure	Waking up the Sensor: The Sensor needs to be woken up to receive information about the new configuration from the controller, like parameters and associations. To wake up the sensor manually, click one of the TMP buttons (while the other button is pressed).
Classic Exclusion	Removing (Exclusion) - Z-Wave device learning mode, allowing to remove the device from existing Z-Wave network. To remove the device from the Z-Wave network: 1. Place the Sensor within the direct range of your Z-Wave controller. 2. Set the main controller into remove mode (see the controller’s manual). 3. Quickly, three times press one of the TMP buttons (while the other button is pressed). 4. Wait for the removing process to end. 5. Successful removing will be confirmed by the Z-Wave controller’s message.
Classic Inclusion	Adding (Inclusion) - Z-Wave device learning mode, allowing to add the device to existing Z-Wave network. To add the device to the Z-Wave network: 1. Place the Sensor within the direct range of your Z-Wave controller. 2. Set the main controller in (Security/non-Security Mode) add mode (see the controller’s manual). 3. Quickly, three times press one of the TMP buttons (while the other button is pressed). 4. Wait for the adding process to end. 5. Successful adding will be confirmed by the Z-Wave controller’s message.