COMMAND_CLASS_BASIC

Basic

0x20

1

Manual_Primary_Lang

Product or Owner's Manual

1

5

0

Group 1 is assigned to the Lifeline association group and every device has 5 nodes to associate. The sensor binary report, basic set or notification report command can be sent in this group when the Sensor is triggered.

1

Which value of the Sensor Binary Report or Basic Set will be sent when the door is Opened/Closed.

To set which value of the Sensor Binary Report or Basic Set will be sent when the door is Opened/Closed.

0

1

0

0

1

111

Set the interval time of low battery checking.

Set the interval time of low battery checking. Note: 1, if the value is less than 10, the time unit is second. If the value is more than 10, the time unit is 4 minutes, which means if the value is more than 10 and less than 240, the interval time is 4 minutes. If the value is more than 240 and less than 480, the interval is 8 minutes. 2, if the current battery report falls below the low battery value (configurable parameter 39), it will send battery report=0xFF.

0

4

0

0

86640

101

Enable/disable the function of parameter 111

Enable/disable the function of parameter 111. Note: this parameter cannot disable the low battery checking of the Sensor itself.

0

1

0

0

1

121

To configure which sensor report will be sent when the door is opened/closed.

To configure which sensor report will be sent when the door is opened/closed.

0

1

0

0

1

252

Lock/unlock all configuration parameters.

Lock/unlock all configuration parameters.

0

1

0

0

0

255

Reset the Sensor.

Reset the Sensor.

0

4

0

0

0

1

Inclusion

Turn the primary controller of Z-Wave network into inclusion mode, short press the product’s Action Button that you can find in the back of the product.

2

Exclusion

Turn the primary controller of Z-Wave network into exclusion mode, short press the product’s Action Button that you can find in back of the product.

4

Device Wake-Up

Press the Action Button once, which will trigger sending out the Wake up notification command, press and hold the Action Button for 3 seconds, which will toggle on/off the Sensor be waked up for 10 minutes.

6

Additional Special Features

Support ""Over the Air Firmware Updating"" and “Z-Wave Security”.

5

Factory Reset

Press the Action Button once that you can find in back of the product for 20 seconds and then release. This procedure should only be used when the primary controller is inoperable.