Product Recognition
Certification Number	ZC10-16030006
Name	Smart Water Leak Sensor
Short Description	The Z-WAVE Water Sensor is able to detect the accidental presence of water, from small leaks to large floods.
Long Description	This sensor sends Z-Wave™ signal while detecting water. The sensor can be put under the refrigerator, and it will trigger while detecting the leaking water. You can also install the sensor at anywhere it leaks; with this sensor you can avoid loss before it flood. When the device is secure included into Z-Wave network, above communication will be encrypted.
Brand	GoControl
Product Identifier	WF00Z-1
OEM Version	01
Hardware Platform	ZM5202
Z-Wave Version	6.51.06
Library Type	SLAVE_ENHANCED_232
Device Type	Notification Sensor
Role Type	ROLE_TYPE_SLAVE_SLEEPING_REPORTING
Manufacturer ID	0x014F
Product Type ID	0x201C
Product ID	0x1C03
Frequency Plans	US: 916.00MHz, 908.40MHz
Categories	Sensors
Countries / Regions	United States of America
Controlled Command Classes	Identifier Name Key Version COMMAND_CLASS_BASIC Basic 0x20 1
Documents	Category Description File Manual_Primary_Lang Product or Owner's Manual 10008416X4 WF00Z-1 Instructions.pdf
Association Groups	Group Number Maximum Nodes Supported End Point ID Description 1 5 0 Z-Wave Plus Lifeline
Texts	ID Description Value 1 Inclusion For “Inclusion” in (adding to) a network: Put the Z-Wave™ Interface Controller into “inclusion” mode, and following its instruction to add the ZF5201 to the controller. To get in the “inclusion” mode, the distance between sensor and controller is suggested to be in one meter. Press the program switch of ZF5201 for 1 second at least. The LED on the ZF5201 should go solid, if not, please try again 2 Exclusion For “Exclusion” from (removing from) a network: Put the Z-Wave™ Interface Controller into “exclusion” mode, and following its instruction to delete the ZF5201 from your controller. Press the program switch of ZF5201 for 1 second at least to be excluded. 4 Device Wake-Up ”Awake” mode: it is to leave the “Sleep” mode by removing the cover of ZF5201, to allow the Z-Wave™ Interface Controller to do “Inclusion”, “Exclusion”, “Association” and to reply and receive the commands from controller. 6 Additional Special Features 1. While detecting water, the sensor will be triggered and send signal to your controller. 2. Normal operation, the LED will not light. 3. If the cover of sensor is removed, the tamper switch will send signal according the Status/Signal table, and the LED will go solid. Before replacing the cover, the sensor is under “Awake” mode. 4. Support OTA Firmware update from the controller. Please refer to your controller manual. 5 Factory Reset Triger the Water Sensor 10 times within 10 sec. The device will send command class of device reset to controller and back to the factory default state. Please use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Supports NWI	Yes
Supports Explorer Frames	Yes