COMMAND_CLASS_POWERLEVEL

Powerlevel

0x73

1

COMMAND_CLASS_BATTERY

Battery

0x80

1

COMMAND_CLASS_VERSION_V2

Version V2

0x86

2

COMMAND_CLASS_WAKE_UP_V2

Wake Up V2

0x84

2

COMMAND_CLASS_DEVICE_RESET_LOCALLY

Device Reset Locally

0x5A

1

COMMAND_CLASS_ZWAVEPLUS_INFO_V2

Z-Wave Plus Info V2

0x5E

2

COMMAND_CLASS_ASSOCIATION_V2

Association V2

0x85

2

COMMAND_CLASS_ASSOCIATION_GRP_INFO

Association Group Info

0x59

1

COMMAND_CLASS_BASIC_V2

Basic V2

0x20

2

COMMAND_CLASS_MANUFACTURER_SPECIFIC_V2

Manufacturer Specific V2

0x72

2

COMMAND_CLASS_NOTIFICATION_V4

Notification V4

0x71

4

Manual_Primary_Lang

Product or Owner's Manual

Battery Quantity

Battery Type

1

5

0

Z-Wave Plus Lifeline

2

Exclusion

To remove the handle from your Z-Wave network, do the following: 1. Open the window / door. 2. Set the Z-Wave controller to the Exclude mode; 3. With the window open, change the handle position at least six times within three seconds, causing the green LED to flash continuously; 4. The handle should now be removed from the Z-Wave network. 5. The red LED flashes once (1 second) if the handle has been successfully excluded.

1

Inclusion

A Z-Wave network controller in Z-Wave terminology can be connected to the handle. If you want to use a Z-Wave network controller, you must add the handle to the network. Proceed as follows: 1. Set the receiver to the inclusion mode 2. With the window open, change the handle position at least six times within three seconds, causing the green LED to flash continuously; 3. The handle should now be added to the Z-Wave network. 4. The green LED flashes once (1 second) when the handle is included

5

Factory Reset

Open the handle. Change window / door position at least 6 times, stopping when the window / door is open. Change the handle position at least 6 times. All this should be completed within 10 seconds. Important: Use this procedure only if the primary network controller is missing or otherwise inoperable.

4

Device Wake-Up

Normally, the handle sleeps to save batteries. He periodically wakes up (by default, once per hour) and sends a wake-up message, after which he can receive messages before he falls asleep again. The user can, e.g. For configuration purposes, request an additional wakeup notification via the following ""manual wakeup"" procedure: 1. Open Handle and then Window / Window Door 2. Change the grip position, wait until the green LED flashes and then within 1 second change the grip position again 3. After 2 seconds, the green LED blinks twice, the wakeup procedure starts.